Victron Multiplus Multi 1200w-12V and 24V Pure Sinewave Inverter Charger
KSh100,000.00 Ex-VAT
- Input Battery Voltage Range: 9.5 – 17 V
- Nominal AC Output Voltage: 230 VAC ± 2%
- Continuous Power Rating: 1200VA @ 25 °C
- Peak Inverter Efficiency: 93%
- Waveform: Pure Sine Wave
- Nominal DC Input Voltage: 12V
- Nominal AC Input Voltage/Frequency: 187-265 VAC, 45 – 55 Hz
- Dimensions: 375x214x110mm
- Weight: 10kg
Victron Multiplus Multi 1200w-12V and 24V Pure Sinewave Inverter Charger
KSh100,000.00 Ex-VATRequest a Call Back
- Ask a Question
Victron Multiplus Multi 1200w-12V and 24V Pure Sinewave Inverter Charger
KSh100,000.00 Ex-VATAsk a Question
Victron Multiplus Multi 1200w-12V and 24V Pure Sinewave Inverter Charger
The Victron MultiPlus is a powerful pure sine wave inverter, a sophisticated multistage battery charger, and a high-speed AC transfer switch in a single compact enclosure. Victron Multiplus is renowned for unbeatable quality and market-leading features. Designed for marine, motorhome & off-grid use.’
Two AC Outputs
The high-speed AC transfer switch ensures continuous AC output with no interruptions. If shore/generator power is disconnected (in the event of a grid failure), the Multiplus takes over the power supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.
Virtually unlimited power thanks to parallel operation
Up to 6 Multiplus inverter/chargers can operate in parallel to achieve higher power output. For example, six 24/5000/120 units will provide 30 kVA output power with 720 Amps charging capacity.
Three phase capability
In addition to parallel connection, three units of the same model can be configured for three-phase output.
PowerControl – Dealing with limited generator, shore side or grid power
The MultiPlus is a very powerful battery charger. It can draw a lot of current from the generator or shore supply. With the Multi Control Panel, a maximum generator or shore current can be set. The MultiPlus will then take over the supply of other AC loads thus preventing the generator or shore supply from being overloaded.
PowerAssist – Boosting the capacity of shore or generator power
Peak power is often required for only a limited period, the MultiPlus will make sure that if shore/generator power is insufficient, it immediately compensates by using power from the battery. When the load reduces to a more normal level, the spare power is used to recharge the battery.
Example: Using the Honda EU10i with Phoenix MultiPlus 12/1600/70. The Honda EU10i delivers a maximum of 1000W. The MultiPlus 12/1600/70 delivers 1600W. So the total available power is 2600W. You have the possibility to simultaneously use heavy power tools, microwave,s and other heavy loads. As soon as the power demand reduces and the generator has enough power available to supply the loads by itself, the inverter function is changed for the charger function and the battery is recharged with a maximum of 70 amps.
Adaptive smart charger and dual bank battery charging
The powerful battery charger uses advanced ‘adaptive charge’ software. The software fine-tunes the three-stage automatic process to suit the condition of the battery and adds a fourth stage for long periods of float charging. An example of advanced charging software is the ‘variable absorption charging time’. Classic 3-step chargers have a fixed absorption time which can easily overcharge the battery if it is activated often throughout the day. The Multiplus charger will adjust the absorption charging time depending on the recent discharge history. This ensures the battery is not overcharged and increases its longevity.
The MultiPlus will charge a second battery bank using an independent trickle charge output intended for a main engine or generator starter battery.
Technical Specifications
Inverter
- Voltage options: DC 12V or 24V
- Input voltage range: DC 9.5-17V or 19–33V
- Input Power (no load): 8W or 10W
- Input Power (search mode): 2W or 3W
- Output voltage (AC): 230V ± 2%
- Output frequency: 50HZ
- Optimum inverter efficiency: 93% or 94%
Charger
- Voltage input: AC 187-265V
- Charge current house battery: 50A or 25A
- Charge current starter battery: 4A
- Charge voltage ‘absorption’: 14.4V or 28.8V
- Charge voltage ‘float’: 13.8V or 27.6V
- Storage mode: 13.2V or 26.4V
- Battery temperature sensor
Transfer switch: 16A
Protection: Output short circuit, overload, battery voltage too low or too high, over temperature, input voltage ripple too high, 230V on inverter output
Battery connection: 1.5m battery cables
Additional items available for this inverter: Phoenix Inverter Control Panel
Victron Multiplus Multi 1200 w/charger features
- Input Battery Voltage Range: 9.5 – 17 V
- Nominal AC Output Voltage: 230 VAC ± 2%
- Continuous Power Rating: 1200VA @ 25 °C
- Peak Inverter Efficiency: 93%
- Waveform: Pure Sine Wave
- Nominal DC Input Voltage: 12V
- Nominal AC Input Voltage/Frequency: 187-265 VAC, 45 – 55 Hz
- Dimensions: 375x214x110mm
- Weight: 10kg
Based on 0 reviews
|
|
0% |
|
|
0% |
|
|
0% |
|
|
0% |
|
|
0% |
brand:
Related Products
- Input Battery Voltage Range: 9.5 – 17 V
- Nominal AC Output Voltage: 230 VAC ± 2%
- Continuous Power Rating: 800VA @ 25°C
- Peak Inverter Efficiency: 92%
- Waveform: Pure Sinewave
- Nominal DC Input Voltage: 12V
- Nominal AC Input Voltage/Frequency: 45 – 55 Hz
- AC input Voltage Range: 187-265 VAC
- Dimensions: 375x214x110mm
- Weight: 10kg
- Input Battery Voltage Range: 38-66V
- Nominal AC Output Voltage: 230VAC
- Continuous Power Rating: 5000VA
- Peak Inverter Efficiency: 95%
- Nominal DC Input Voltage: 48V
- Frequency Range AC Input: 45-65Hz
- Dimensions: 444x328x240mm
- Weight: 30kg
- Input Battery Voltage Range: 10.5V – 15.5V
- Nominal AC Output Voltage: 110VAC or 230VAC
- Continuous Power Rating: 375VA
- Peak Inverter Efficiency: 89%
- Waveform: Pure Sine Wave
- Nominal DC Input Voltage: 12V
- Dimensions: 72x155x237mm
- Weight: 3.5kg
- Input Battery Voltage Range: 19 – 33 V
- Nominal AC Output Voltage: 230 VAC ± 2%
- Continuous Power Rating: 2000VA at 25 °C
- Peak Inverter Efficiency: 94%
- Waveform: Pure Sine Wave
- Nominal DC Input Voltage: 24V
- AC input Voltage Range: 187-265 VAC
- Frequency Range AC Input: 45 – 55 Hz
- Dimensions: 520x255x125
- Weight: 12kg
- Model 650VA 850VA 1000VA 1450VA 2000VA
- Nominal Battery Voltage 12 VDC 24 VDC
- Solar Panel Connected to 50 Amps
- PWM/MPPT* Charge Controller (Max.)
- 850Wp 1700Wp
- AC Mains Mode
- Input Voltage Range (Eco Mode) 100 to 280 VAC ± 5 VAC (Wide Range)
- Input Voltage Range (Inv. Mode) 180 to 260 VAC ± VAC
- Changeover Time Maximum < 30 ms (in Eco Mode) and < 10 ms (in Inv. Mode)
- Charging Current (NC) 5A± 1A
- Charging Current (HC) 22A ± 1A
- PowerControl: YES
- PowerAssist: YES
- Transfer switch (A): 50A
- Parallel and 3-phase operation: YES
- Input Battery Voltage Range: 38-66V
- Nominal AC Output Voltage: 230VAC
- Continuous Power Rating: 5000VA
- Peak Inverter Efficiency: 95%
- Nominal DC Input Voltage: 48V
- Frequency Range AC Input: 45-65Hz
- Dimensions: 444x328x240mm
- Weight: 30kg
- Model: 650VA 850VA 1000VA 1450VA 2000VA
- Nominal Battery Voltage: 12 VDC 24 VDC
- Solar Panel Connected for 50 Amps
- PWM/MPPT* Charge Controller (Max.)
- 850Wp 1700Wp
- AC Mains Mode
- Input Voltage Range (Eco Mode) 100 to 280 VAC ± 5 VAC (Wide Range)
- Input Voltage Range (Inv. Mode) 180 to 260 VAC ± VAC
- Model 2KVA/2.5KVA/3.5KVA/5KVA/7.5KVA/10KVA/12KVA/15KVA
- AC Mains Mode
- Input Voltage Range (Eco Mode) 100 to 280 VAC ± 5 VAC (Wide Range)
- Input Voltage Range (Inv. Mode) 180 to 260 VAC ± VAC
- Changeover Time Maximum < 30 ms (in Eco Mode) and < 10 ms (in Inv. Mode)
- Charging Current (NC) 5A± 1A
- Charging Current (HC) 22A ± 1
- Boost Charging Voltage 14.4 ± 0.2 VDC per Batt.
- Float Charging Voltage 14.4 ± 0.2 VDC per Batt.
- Model: MOD 10KTL3-X | MOD 11KTL3-X | MOD 12KTL3-X | MOD 13KTL3-X | MOD 15KTL3-X
- recommended PV power: 15000W | 16500W | 18000W | 19500W | 22500W
- DC voltage: 1100V
- Start Voltage: 200V
- Nominal voltage: 580V
- of MPP trackers: 2
- AC nominal power: 10000W | 11000W | 12000W | 13000W | 15000W
- Nominal AC voltage: 220V/380V, 230V/400V (340-440V) | 50/60 Hz (45-55Hz/55-65 Hz)
- Brand: Livguard
- Model Name: 4.0kva MPPT
- Capacity: 4000w
- Waveform: Pure Sine Wave
- Output Voltage: 220
Reviews
There are no reviews yet.